We found 10 results matching your criteria.
About Powerlock Spiral Heads
Similar in design to standard spiral planerheads, but with an integrated HSK shank.
For exclusive use on all Weinig Powermat moulders.
- Rated for maximum speed of 12,000 rpm up to 240mm width
- Rated for maximum speed of 8,000 rpm over 240mm width
Using a spiral-cut tool on natural wood can make the cutting process smoother, often dramatically improving finish quality. These advantages are particularly beneficial when cutting material that is cross-grained, knotty, or of a “stringy” layered structure.
- Noise reduction (up to 20 decibels)
- Reduced cutting pressure (up to 20%)
- Reduced tearing
- Less severe cutting action
- Less tendency to create chip dents
- Less raised grain
- Should a knife nick occur, only a single 4-sided insert knife must be rotated or replaced. No grinding required.
- Insert knives uniquely designed with a slight convex curve on the cutting edge to prevent lines from appearing on the wood surface.
IMPORTANT NOTE:
Do not mismatch replacement carbide insert knives. All knives must be from the same supplier, in order not to affect balance.
