Spiral Powerlock
We found 10 results matching your criteria.
Similar in design to standard spiral planerheads, but with an integrated HSK shank.
For exclusive use on all Weinig Powermat moulders.
• Rated for maximum speed of 12,000 rpm up to 240mm width
• Rated for maximum speed of 8,000 rpm over 240mm width
Using a spiral-cut tool on natural wood can make the cutting process smoother, often dramatically improving finish quality. These advantages are particularly beneficial when cutting material that is cross-grained, knotty, or of a “stringy” layered structure.
• Noise reduction (up to 20 decibels)
• Reduced cutting pressure (up to 20%)
• Reduced tearing
• Less severe cutting action
• Less tendency to create chip dents
• Less raised grain
• Should a knife nick occur, only a single 4-sided insert knife must be rotated or replaced. No grinding required.
• Insert knives uniquely designed with a slight convex curve on the cutting edge to prevent lines from appearing on the wood surface.
IMPORTANT NOTE:
Do not mismatch replacement carbide insert knives. All knives must be from the same supplier, in order not to affect balance.
Bottom Spiral Head - 270mm
